In the construction of construction site, we usually use mortars, so we often because of some construction requirements, weather and other objective conditions, workers usually use portable electric bricks mixed use, in the use process often encounter a variety of problems. The reasons for the difficulty in mixing Jinan plastering mortar are as follows:

　　首先,的力量使用的便攜式電動磚工人缺乏,需要更換混合器與一個較小的直徑,需要鋼筋的直徑也有一個小的直徑,所使用的電力機不小于700 w,使用低速混合機混合。

　　First of all, the strength of the use of portable electric brick workers is lack, need to replace the mixer with a smaller diameter, need to have a smaller diameter of the diameter of the steel bar, the electric machine used is not less than 700 W, use low-speed mixer to mix.

　　二、在攪拌砂漿的時候，工人加的水少，按照施工說明是按照加水量的，如果水太少，水灰比很低，那么就會有攪拌的問題。

　　2. When mixing mortar, workers add less water. According to the construction instructions, the amount of water is added. If the water is too little and the water cement ratio is very low, there will be mixing problems.

　　3、包裝袋使用紙塑料復合一分之三包裝方法進行包裝,內袋包裝袋子很容易被轉移到攪拌器打開和使用時,內袋將傷口上面的攪拌機攪拌棒,所以混合收到阻力,增加混合的困難。

　　3. The packaging bag is packaged by three thirds of the paper plastic composite packaging method. The inner bag packaging bag is easy to be transferred to the mixer when the mixer is opened and used. The inner bag will stir the mixer bar above the wound, so the mixing resistance is received, which increases the difficulty of mixing.

　　所以,當水消費需求規范,按照制造商的證書上面的水補充填寫目標,應該使用根據稱量每個包的規范的砂漿用于注水,相應的在容器中的位置校準記錄,要求規范混合比例,注意紋理調查漿后,確保質量的混合。如果加水后，覺得水太多，不允許用部分粉末材料倒水，否則會影響數據的功能，需要在繼續混合后再增加粉末材料。

　　Therefore, when the water consumption requirements are standardized and the water replenishment target is filled in according to the manufacturer's certificate, the mortar according to the specifications of each package shall be used for water injection, and the corresponding position in the container shall be calibrated to record, and the mixing proportion shall be standardized. Pay attention to the texture investigation slurry to ensure the quality of mixing. If there is too much water after adding water, it is not allowed to pour water with some powder materials, otherwise the function of the data will be affected, and the powder materials need to be added after further mixing.

　　以上是濟南抹面砂漿小編為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://www.hszy8818.cnThe above is the introduction of Jinan plastering mortar. To learn more, please visit http://www.hszy8818.cn